AUTRY TECH DRAFTING/DESIGN

Read Chapter 18 on page 615. Answer the question below and enter into OPEN LMS under 3M14

​

​

1. Metal that is added to a weld is referred to as metal.

​

A. adder

B. flux

C. brazing

D. filler

E. none of the above

​

2. A ____ is used to indicate the type of weld to be used.

​

A. welding symbol

B. weld symbol

C. callout

D. local note

E. feature control frame

​

3. The most common form of gas welding is ____ welding.

​

A. gas tungsten

B. oxhydrogen

C. oxyacetylene

D. pressure gas

E. inert gas

​

4. Gas welding is normally used for

​

A. automated welding systems.

B. structural welding.

C. field welds.

D. mass production.

E. repair and maintenance.

​

5. One of the commonly used welds is the ____ weld.

​

A. spot

B. backing

C. groove

D. fillet

E. seam

​

6. A specific welding or allied process may be specified in 

​

A. the body of the welding symbol.

B. the tail of the welding symbol.

C. a general note.

D. a local note.

E. a process note.

​

7. The terms far side and near side

​

A. Are no longer used.

B. indicate weld location.

C. are synonymous with arrow side and other side.

D. are used in local notes only.

E. are used in specifying field gas welds.

​

8. Finished of welds, other than cleaning, is indicated

​

A. by a contour symbol.

B. by a finish symbol.

C. by a callout.

D. in the body of the welding symbol.

E. in the tail of the welding symbol.

​

9. The center-to-center spacing of intermittent fillet welding is referred to as

​

A. jump.

B. pitch.

C. spacing.

D. gap.

E. offest

​

10. The root opening in groove weld design is to permit 

​

A. the flow of metal.

B. expansion during the welding process.

C. the escape of accumulation gases.

D. access by the welding electrode.

E. easier access for inspection.

​

11. The quality of a weld is affected by the

​

A. type of weld.

B. design of the weld.

C. preparation of the weld area.

D. all of the above

E. none of the above.

​

12. A field weld is

​

A. not made at the place of initial construction or fabrication.

B. made at the place of initial construction or fabrication.

C. made in an open fabrication are.

D. specified on site to adjust for local conditions.

E. a partial weld for repair purpose. 

 

​